Speaker setting, Audio setup – Kenwood KDC-BT742U User Manual
Page 21
English
|
21
Function of KDC-X493/MP442U
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
Display
OFF
“SP SEL OFF”
For 5 & 4 in. speaker
“SP SEL 5/4”
For 6 & 6x9 in. speaker
“SP SEL 6x9/6”
For the OEM speaker
“SP SEL OEM”
1
Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2
Enter Speaker Setting mode
Press the [AUD] knob.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.
Audio Setup
You can set Sound system , such as follows;
Adjustment Item
Display
Range
Front High Pass
Filter*
“HPF F”
Through/40*
/60*
/80/100/
120/150/180/220*
Hz
Rear High Pass
Filter*
“HPF R”
Through/40*
/60*
/80/100/
120/150/180/220*
Hz
Low Pass Filter*
“LPF SW”
50*
/60/80/100*
/120/
Through Hz
Subwoofer Phase*
“SW PHASE”
Reverse (180°)/ Normal (0°)
Volume offset
“V-OFFSET”
–8 — ±0 (AUX: -8— +8)
Dual Zone System
“2ZONE”
OFF/ON
* Function of KDC-X493.
* Function of KDC-MP442U.
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “ZONE2” of
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by
(page 20) or [
5]/[∞] button on the remote control
(page 34).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
B64-4314-00_00.indb 21
08.11.1 2:43:46 PM