Kenwood KDC-BT742U - Manual (Page 23)

English |
23
Cabin selection
You can compensate the delay of the sound arrival
time by selecting your environment from the
following car types;
Car type Display
Not compensating. “OFF”
Compact car “COMPACT”
Full size car “F-SIZE”
Station wagon “WAGON”
Minivan “MINIVAN”
Sport-utility vehicle “SUV”
Minivan Long “MV-LONG”
1 Enter Cabin select mode
Select “DSP” > “SETUP” > “CABIN”.
For how to select Function Control item, refer to
(page 6).
2 Select the car type
Turn the [AUD] knob and push the center when
the desired item is displayed.
3 Exit Cabin select mode
Press the [SEARCH] button.
⁄
• You can compensate the distances in more details by
using (page 23) function.
Speaker Setting
Setting the speaker to be connected, speaker size,
and installation position;
Setting speaker Display Range
Front
“FRONT” Speaker
Location “LOCATION” “DOOR”/ “ON DASH”/
“UND DASH”
Speaker
Size “SIZE” “SMALL” / “MEDIUM”/ “LARGE”
Tweeter “TWEETER” “NONE”/ “USE”
Rear
“REAR” Speaker
Location “LOCATION” • “DOOR”/ “REAR DECK”
• “2ND ROW”/ “3RD ROW”
(Minivan/ Passenger van)
Speaker
Size “SIZE” “NONE”/ “SMALL” / “MEDIUM”/
“LARGE”
Subwoofer
“SUB-W” Speaker
Size “SIZE” “NONE”/ “SMALL” / “LARGE”
1 Enter Speaker Setting mode
Select “DSP” > “SETUP” > “SPEAKER”.
For how to select Function Control item, refer to
(page 6).
Audio Adjustments (DSP)
Function of KDC-BT742U
2 Select the item you want to set
Turn the [AUD] knob and push the center when
the desired item is displayed.
3 Set the value
Turn the [AUD] knob and push the center when
the desired item is displayed.
4 Exit Speaker Setting mode
Press the [SEARCH] button.
DTA (Digital Time Alignment) setting
Adjusting fine tuning of the speaker position
compensation value specified at
(page 23).
1 Enter DTA setting mode
Select “DSP” > “SETUP” > “DTA”.
For how to select Function Control item, refer to
(page 6).
2 Select the speaker you want to set
Setting speaker Display
Front speaker “FRONT”
Rear speaker “REAR"
Subwoofer “SUB-W"
Turn the [AUD] knob and push the center when
the desired item is displayed.
3 Set the compensation value of the speaker
position
Turn the [AUD] knob and push the center when
the desired value is displayed.
Adjust between 0 and 14.44 feet.
Refer to (page 38) on how to set the
compensation value.
4 Exit DTA setting mode
Press the [SEARCH] button.
B64-4314-00_00.indb 23 08.11.1 2:43:46 PM