KTI Networks 24-PORT KGS-2401 - Manual (Page 27)

-27-
7. Command Line Interface
7.1 Start-up and Terminal configuration
To start-up the command line interface, connect a PC COM port to the RS-232 connector and activate
a terminal emulation software (e.g. HyperTerminal of Windows.). The terminal emulation software
should be set up as follows:
1. Data rate: 115200 baud
2. Data format: 8 data bits, 1 stop bit and no parity
3. Flow control: none.
4. Click the property icon, select settings, make sure that:
The Function, arrow, and ctrl keys act as: Terminal keys
Emulation: VT100
7.2 Login/Logout Procedures
To get access to the CLI, you will have to get the username and password for login. One set of default
username/password is identified with admin/admin.
You may logout at any time and at any context level using the exit command.
Note:
It is suggested to change the default and configure a new username/password to prevent unau-
thorized users from accessing to the device.
7.3 Command Hierarchy
The CLI (Command Line Interface) is hierarchical with two levels: a top level and a group level. The
group level consists of the following groups:
• System
• Console
• Port
• MAC
• VLAN
• Aggr(Aggregation)
• QoS
• Mirror
• IP