Kenwood MD-2070 - Manual (Page 50)

DMF-9020/MD-2070 (En)
50
PHONES
Timer operations
1
Turn the powers of the associated components ON.
Playback or recording can also be activated at the desired
time by using a commercially available timer.
Audio timer
Connect the power cords of the associated components so
that their power can be turned ON through the audio timer.
Also, be sure to read carefully the instruction manual of the
timer.
Do not set timer recording in a way that the power is not turned
ON for more than 3 days; otherwise, the last recorded data
may be cleared.
Tuner
Amplifier
Audio cord
DMF-9020/MD-2070
Audio cord
Timer playback, timer recording
÷ Set the POWER key of the unit to ON.
For timer playback
1
Load a recordable Mini
Disc.
2
Receive the desired radio
station.
3
Select the desired mode
with the REC INPUT key.
§
4
Adjust the recording level.
Make preparations.
÷ For timer recording, be sure to set the write protect tab to enable
recording. 8
÷ For timer recording, be sure to check the remaining recording time.
o
2
5
÷ After having set the timer, be careful not to press the ON/STANDBY
key of the remote control unit to ON; otherwise the timer operation
would be activated.
Set the timer so that the
tuner reception can be
started at the desired time
of the day. Set the timer so that it sup-
plies power at the specified
time.
Set the timer ON time.
4
For timer recording
Set the TIMER.
÷ When the set time comes, the disc playback or recording starts
automatically. (Also be sure to read the instruction manual of the
connected component carefully.)
1
Play the Mini Disc.
2
Adjust the amplifier vol-
ume.
3
Stop the disc.
Minimize the amplifier vol-
ume.
3
Set the amplifier volume.
Refer to “Memory backup”. 9
Load a prerecorded Mini
Disc.
For timer recording
For timer playback For timer recording
For timer playback
For timer playback For timer recording
TIMER
OFF
PLAY REC
TIMER
OFF
PLAY REC