Kenwood MD-2070 - Manual (Page 26)

DMF-9020/MD-2070 (En)
26
Adjust the settings if required.
1
2
1
Switch the REC MODE on.
2
Select the setting adjustment mode.
3
Set the selection (by pressing the JOG DIAL).
Go to step 2 if setting adjustments are not required.
The input jacks connected with audio cords accept analog signals. This unit records the analog signal from the REC IN jacks by
converting it into digital signal. (This recording is simply referred to as analog recording.)
Recording (ANALOG input)
÷ MONO cannot be selected during recording pause.
÷ The REC INPUT cannot be changed during pause in the MONO mode.
÷ The analog “monaural long-play mode”allows to double the recording
time compared to recording in the stereo mode.
Preparation
Each press switches the mode.
1 REC MODE : off
2 REC MODE : on
Select ANALOG or MONO.
Each press switches the mode.
1 ANALOG : Analog “stereo mode”
2 DIGITAL 1 : Coaxial input mode
3 DIGITAL 2 : Optical input mode
4 DIGITAL 3 : Coaxial input mode
5 MONO
: Analog “monaural long-play mode”
“ANALOG” lights up
1
Open the write protect tab of the Mini Disc to make it recordable. 8
2
Load the Mini Disc.
3
Check the remaining recording time. o
4
Set the amplifier’s input selector to the source to be recorded.
ANALOG recording
÷ For details on the setting adjustment modes, see “REC MODE key”.
£
OVER ( − dB)
R
L
A N A L O G
∞
15 9 12 7 5 1 3 40 30 21 18 0
SEARCH PGM
MONITOR
ANALOG
32kHz
2 1 3
48kHz
44.1kHz
DIGITAL
REC MODE
/CHARAC.
4 ¢
U P DOWN
PUSH SET
JOG DIAL
4 ¢
U P DOWN
PUSH SET
JOG DIAL
REC INPUT
The modes are switched by rotating the JOG DIAL.
D. REC LEVEL? : Digital recording level setting.
AUTO CUT? : AUTO CUT on/off selection.
AUTO TIME? : Setting of the time for detecting a no-sound
blank section during automatic track number
marking.
AUTO LEVEL? : Automatic track number marking no-sound
blank detection level and SOUND SYNCHRO
REC, AUTO CUT and REC AUTO PAUSE sound
detection level setting
FADE TIME? : Setting of the fading time in fade-in and fade-
out.
REC = WRITING? : Setting of the UTOC writing after recording.
÷ The “D.REC LEVEL” and “FADE TIME” settings are not used during
analog source recording.