Kenwood MD-2070 - Manual (Page 27)

DMF-9020/MD-2070 (En)
27
Each press switches the mode.
1 goes off (AUTO) : Track numbers are marked automatically.
£
2 MANUAL : Track numbers can be marked as desired.
£
Extinguished in “AUTO” mode, lit in “MANUAL” mode.
Recording is not possible if the following characters are displayed.
“DISC FULL” : Disc is full
\Erase undesired tracks.
‚w
“PROTECTED” : The accidental erasure protect tab is open.
\Close it.
8
“PLAY ONLY” : A playback-only Mini Disc is loaded.
\Load a recordable Mini Disc.
÷ When the EDIT / SPACE key is pressed during recording, a track
number is inserted in that position.
After recording, eject the Mini Disc.
Start recording.
Information is
being written. Mini Disc has been ejected.
Select “AUTO” or “MANUAL”. (Remote control unit only)
Adjust the recording level. (Main unit only)
1
Press the 8 key.
2
Play the source to be recorded from the beginning.
Recording (ANALOG input)
OVER ( − dB)
MANUAL
R
L
0 0 1
∞
15 9 12 7 5 1 3 40 30 21 18 0
SEARCH PGM
MONITOR
ANALOG
32kHz
2 1 3
48kHz
44.1kHz
DIGITAL
N O D I S C WRITING EJECT
4
3
5
6
÷ The eject (0)key is not accepted during recording.
While “WRITING” is displayed, do not apply shock
or vibration to the unit because information is
being written on the Mini Disc.
Note Note Note
AUTO/MANU.
1
Play the source to be recorded.
2
Press the ¶ key.
3
Adjust the recording level and balance.
Recording level
(inner knob)
To attenuate
the L CH To attenuate
the R CH To increase
level To decrease
level
Recording balance
(outer knob)
8 ¶
REC LEVEL REC BALANCE
MIN
L R
MAX
REC LEVEL REC BALANCE
MIN
L R
MAX
8 ¶
0
÷ The unit enters record-pause mode automatically when the ¶ key is
pressed.
÷ Decrease the level if the red segments of the peak level meter light.