Kenwood HM-353V - Manual (Page 50)

50
Timer operation
Application section
Put the unit in standby mode.
6
÷ When the unit enters the Standby mode, the standby/
timer indicator lights in green.
÷ If there is a power failure or the power cord is un-
plugged after the timer reservation has been activated,
the standby/timer indicator blinks in green. In this
case, the clock setting should be restarted from the
beginning.
÷ When the timer setting is completed by pressing the
set/demo key, "COMPLETE !" is displayed.
÷ When "PLAY" is selected, the timer playback will
start at the volume setting used at the moment the
unit is set to the Standby mode.
÷ When the timer setting is completed by pressing
the set/demo key, "COMPLETE !" is displayed.
÷ The sound is muted during timer recording. If you
want to monitor the recorded sound, turn the vol-
ume/multi control knob (or press the VOLUME key
on the remote) to adjust the volume.
Reserve the timer operation.
÷ Press the TIMER key on the remote repeatedly until
"PROG. 1", "PROG. 1 2" or "PROG. 1 2" lights.
÷ To cancel timer reservation after it has been activated,
press the TIMER key while the unit is on so that all of
the timer-related indicators are turned off. (The setting
made above is still left in memory.)
5
To check or modify the reservation contents, restart the timer reservation from the beginning.
3
Select the broadcast station (only when
TUNER is selected above).
(1) Select the preset station No.
(2) Set it.
3
Select the broadcast station (only when
TUNER is selected above).
(1) Select the preset station No.
(2) Set it.
Each press switches the timer as follows.
1 "O.T.T."
2 "PROG.
1 "
3 "PROG. 1 2 "
4 "PROG. 1 2 "
5 Extinguished
TIMER
POWER
\ \
set / demo
\ \
set / demo