Kenwood HM-353V - Manual (Page 22)

22
Playback of tape
Basic section
To wind tape at high speed
÷ Press the 7 STOP key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
To fast wind in
direction
\
To fast wind in
direction
|
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." ON
( TAPE equalizer is used)
2 "TAPE EQ." OFF
( TAPE equalizer is not used )
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the re-
cording condition of the tape.
To stop playback
STOP
RETURN
TUNING
Selection of reverse mode
The tape counter is set to "0000" when a cas-
sette tape is loaded. By writing down the
counter reading in case you want to interrupt
recording (playback) in the middle of the tape,
the memo will be helpful as a reference for lo-
cating the same position when continuing the
recording (playback) the next time. The tape
counter figure decrements during recording or
playback of the back side (while the
2 tape
transport indicator is lit). To set the tape counter
to "0000", open the cassette holder once. Then
the counter will be reset.
A tip for use of the tape counter
1 Select "TAPE RVS. ?".
2 Select.
3 Set it.
1 " " : (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and then
the tape stops. (When the playback direction is
"
2", however, the tape stops after one side has
been played (recorded).
3 " " : (ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides.When the
playback direction is "
2", however, the tape stops
after one side has been played ).
(The initial setting is " "(REVERSE))
(Press the set/demo key while the "?" mark is
blinking)
volume / multi control
\ \ \ \
menu set / demo
set / demo
TAPE EQ.
Main unit only