Kenwood HM-353V - Manual (Page 28)

28
Various CD playback features
Application section
Let the "PGM" indicator light.
Select track numbers in the order you want to play them.
Start playback.
Select the CD input.
÷ A track can also be selected using the 4 or ¢ key.
÷ Up to 32 tracks can be programmed. When "FULL" is dis-
played, no more tracks can be programmed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 256 minutes or
more, the time display shows "- - : - -".
1
Select the track.
2
Confirm the selection.
Lights
Selection of tracks
(Go to step
2
within 4 seconds.)
Press the numeric keys as shown below....
To select track No. 23 : +10
X
2, 3
To select track No. 40 : +10
X
4, 0
Various CD (CD-DA, VIDEO CD and MP3 file) playback features
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
1
2
3
Program position of the track
to be selected next.
(To select more than one track, repeat steps 1 and
2 for each track.)
÷ Tracks will be played in the order they were pro-
grammed (following the program numbers).
÷ When the 4/ ¢ key is pressed during play, the pro-
gram will jump to the preceding or the following track
respectively.
Press in stop mode
Listening to the desired sequence
(PGM )
A non-finalized CD-R cannot be played back.
AUTO//MONO
PGM
SET
CD
SELECT
9
6
3
0
8
5
2
10
7
4
1
P G M C D
P G M C D
CD-DA VIDEO CD (with PBC OFF *)
Symbols in the text indicate the disc media that can be played back. CD-DA VIDEO CD MP3 file