Kenwood HM-353V - Manual (Page 25)

25
Basic section
One-by-one presetting (Manual preset)
1 Select the AUTO or MANUAL mode.
÷ The same operation is also available with the 7 STOP
[Tuning Mode] key on the main unit.
2 Tune a station.
Tuning a non-preset radio station (Auto tuning, Manual tuning)
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good: AUTO
mode
When it is poor due to weak radio waves:
MANUAL mode
In AUTO mode :
The next preset station can be received automatically
each time the TUNING UP/DOWN (
1 or ¡) key is
pressed.
In MANUAL mode :
Press the TUNING UP/DOWN (
1 or ¡) key repeat-
edly until the desired station is received. The desired
station can also be received by holding the TUNING
UP/DOWN (
1 or ¡) key depressed until its fre-
quency is displayed.
To increase
frequency To decrease
frequency
Each press alternates the mode.
1 "AUTO" :
Stereo reception("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
1 Perform the procedure in "Tuning a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
3 Select one of the preset numbers from
1 to 30.
4 Press the ENTER key again.
÷ In MANUAL mode, FM stations are received in monau-
ral.
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
÷ A maximum of 30 stations of the band presently being
received will be preset.
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
(Proceed to step
3 while "MEMORY" is lit.)
"MEMORY" lights (for approx. 20 sec.)
Receiving broadcast station
Remote control unit only
AUTO//MONO
PGM
ENTER
N
E
X
T
P
R
E
V
.
P. CALL P. CALL
ENTER
TUNING
Remote control unit only
9
6
3
0
8
5
2
10
7
4
1
M E M O R Y