Automatic adjustment of the recording level (crls), Dolby hx pro, Points for recording from a cd or an md – Kenwood FM/AM Reciever R-SE7 User Manual
Page 30
R-SE7/DP-SE7/X-SE7 (En)
30
Preparation section
Basic section
Application section
Knowledge sections
Recording
To repeat a recording
Press the rewind key during recording.
Automatic Adjustment of the Recording Level (CRLS)
A standard recording level has been set in advance for the cassette deck (X-SE7), but when the CRLS
function is used, the max. recording level is set automatically for the music source.
2 Press the CRLS key.
÷ If there is a non-recorded space of more than 4 seconds
before the recording start position, recording is aborted
and tape is rewound as shown below.
÷ If there is no recorded tune before, the tape will be
rewound then stopped.
Tape stops after 2 sec. of transport.
Tune to be re-recorded
Blank of 4 sec. or more
Re-recording
Recorded tune
Dolby HX Pro
The Dolby HX Pro headroom extension system records high frequencies such as the cymbal sound clearly by controlling
the bias current during recording according to the frequency composition of the sound being recorded. This system is
activated automatically during recording with this unit.
Points for Recording from a CD or an MD
For recording from a CD or an MD, playback from
the music source and recording by the cassette deck
can be started simultaneously (synchro recording
function) when the cassette deck is set to record
pause status in advance.
1 Pause the CD or MD to be played.
2 Use the skip keys (4 ¢) to select the title
to be recorded. (Pause will be reached at the
beginning of the selected title.)
3 Bring the cassette deck to recording pause
condition.
4 Start playback of the CD or MD.
(Synchro recording will start.)
÷ The recording is stopped when the stop key of the
playback unit is pressed.
During recording of re-
verse side (while
2 is lit)
During recording
of top side
(while
3 is lit)
If the key has never been pressed
.....The sound is recorded with the basic level set with the
unit.
If the key is pressed
.....The recording level is set automatically and stored in
memory as the recording level to be used with the
current input being selected. From the next time on,
this recording level is set automatically for that input
even if the key is not pressed.
To return to the basic level
.....Hold the key depressed until the indicator goes off
(for approx. 3 seconds).
÷ The recording level setting completes in approx. 20
seconds, after which the deck enters the record-pause
mode.
÷ If recording is started during the setting (while the CRLS
indicator is blinking), distorted sound may be recorded.
÷ If a non-recorded space of more than 3 seconds is
detected after the CRLS key is pressed, the recording
level setting is aborted.
1 Play the contents to be recorded
(or receive the radio station to be recorded).
About 20 sec
Return to the recording start position.
1
¡
CRLS
CRLS
CRLS