Connection of speakers, R-se7, 1 cord preparation. 2 loosen. 3 insert. 4 secure – Kenwood FM/AM Reciever R-SE7 User Manual
Page 12: Speaker (left) (6-16 ω ) · ª ª
R-SE7/DP-SE7/X-SE7 (En)
12
Preparation section
Basic section
Application section
Knowledge sections
System connection
SYSTEM
CONTROL
ANTENNA
AM
GND
FM75
CD
IN
IN
REC
PLAY
SUPER
WOOFER
PRE OUT
SPEAKERS
( 6 - 16
)
L
R
TAPE
REC
PLAY
MD
AUX
R
L
SPEAKERS
( 6 - 16
)
L
R
SUPER
WOOFER
PRE OUT
Speaker (right)
(6-16
Ω
)
Connect the speakers as shown in the figure.
Do not plug the power cord into a wall AC outlet until the connection has been completed.
3. Connection of speakers
1 Cord preparation.
2 Loosen.
3 Insert.
4 Secure.
R-SE7
¶ Never short-circuit the + and – speaker cords.
The protection circuit will operate and no sound will
be put out.
¶ If the left and right speaker connections or the + and
– polarity are inverted, the sound will be unnatural
with unclear localization of musical instruments, etc.
Be sure to connect them without mistake.
Speaker (left)
(6-16
Ω
)
·
ª
ª
·
Super woofer (SW-500) (optional)
Extremely low frequency sound is played back powerfully.
This can be used with any type of playback.