Kodak i800 Series - Manual (Page 16)

A-61510 January 2005 2-10
Jam and Fault recovery This section provides recommendations for application logic
associated with scanner jam and fault recovery.
If your scanner is enabled and you are polling when a document jam
or other fault occurs, use the following procedure to restart
scanning.
IMPORTANT: Before beginning fault recovery, make sure all the
headers and images have been transferred from the
image buffer to the host system.
When a document jam or other fault occurs, the feeder and the
transport will stop and the scanner will be disabled.
1. When all images have been retrieved from the scanner
(image buffer empty), display the last image retrieved for
operator viewing.
2. Use the image header of the last image retrieved to
determine the image address and sequential counter.
3. Use the information above +1 to seed the next image
address and sequential counter before re-enabling the
scanner.
4. Instruct the operator to sort through the stack of documents
being scanned to find the document that produced the last
successfully scanned image. They must rescan all of the
documents that follow the last successfully scanned
document.
5. Enable the scanner.