Kodak i800 Series - Manual (Page 105)

A-61510 January 2005
4-24
Response  allows you to specify the action that will be taken when the
transport timeout has been reached.
• Stop Feeder and Transport: stops the feeder and the transport but
leaves the scanner enabled. Scanning may be resumed by pressing
the Start/Resume button.
• End Job: stops the feeder and the transport and disables the
scanner. Scanning cannot be resumed until the scanner is enabled
by the host.
Enabling Lamp Saver mode Enabling Lamp Saver extends lamp life and reduces energy
consumption. This value is the amount of time (in minutes) the scanner
will wait after the last document enters the transport before the lamps
will turn off. If enabled, you can specify a time delay setting from 1 to 30
minutes. The default is 10 minutes. If this option is disabled, the lamps
will remain on until the power is turned off.
Assigning Function Keys This section is used to assign actions the operator uses from the
Operator Control Panel. Function Key #1, Function Key #2 and Function
Key #3.
Available functions are:
• End-of-Job
• Terminate Batch
• Omit Multi-feed Detection on Next Document
• Do not Print on Next Document
• Omit Patch Reading on Next Document