Kenwood RC-2000 User Manual

Page 37

3 Press [V/M] to return to the frequency adjustment

mode. If necessary, press the Tuning control to
toggle between the Tuning and MULTI/ CH control.

SATELLITE CHANNEL NAME

You can name each Satellite Memory channel using a
maximum of 8 alpha-numeric characters. First, store the
settings to the Satellite Memory channel {above}.

1 Press [M.IN] while in group A–4, then turn the

MULTI/ CH control to select your desired Satellite
Memory channel.

2 Press [MN.IN].

•

An entry cursor appears.

3 Select a character by turning the MULTI/ CH control,

then move the cursor using [

[

]/ [

]. Press [M.SR]

to go back to Memory Scroll mode. Press [DEL] to
erase the character at the cursor. You can also use
the optional MC-52DM microphone to enter a name
{TS-2000 page 63}.

4 Press [OK] to store the name to the Satellite Memory

channel. Press [CLR] to quit.

5 The stored Satellite Memory name appears above the

main band frequency display on the RC-2000.

QUICK MEMORY IN SATELLITE MODE

While in the Satellite mode, only 1 Quick Memory
channel is available. It uses Satellite Memory channel 9
to store the settings. To store the settings to the Quick

Memory in Satellite mode, press [Q.IN] (L2). The
settings are stored to Satellite Memory channel 9.

To recall the Quick Memory, press [Q.M] while in group
B–4 or press [V/M] while in group A–2, then turn the
MULTI/ CH control to recall the Satellite Memory
channel 9.

CHECKING THE UPLINK FREQUENCY

When you need to monitor the uplink (TX) frequency,
press [M/S] while in group A–2. Each time you press
[M/S], the uplink (TX) frequency and the downlink (RX)
frequency are swapped.

USING XIT/ RIT IN SATELLITE MODE

You can also use the RIT or XIT function while in the
Satellite mode. Press [RIT] (R2) or [XIT] while in group
A–2 to activate the function. When the RIT or XIT
function is ON, the sub-band frequency display shows
the current RIT or XIT offset frequency instead of the
operating frequency. To clear the RIT or XIT offset
frequency, press and hold [RIT] or [XIT].

Note: You cannot activate both the RIT and XIT functions at the same
time in the Satellite mode.

CHANGING THE FREQUENCY BAND

Press [M/S] while in group A–3 to select the band you
want to change on the main band, then press [UP]/
[DOWN] while in group A–1 to select the band you want
to operate. Press [M/S] again to swap the bands.