Kenwood RC-2000 - Manual (Page 24)

20
GROUP B–3
SCAN
Press to start or stop various Scan functions.
AUTO
Press to switch the Auto mode selection function ON or
OFF. When it is active, “A” appears on the display.
SG SEL
Press to enter the Scan Group select mode. Select your
desired memory group numbers using the [
b ]/ [ a ] key,
or by turning or pressing the MULTI/ CH control, then
press [SEL] to toggle the selection. The selected group
numbers are highlighted. You can also press [ALL] to
deselect all the group numbers. Press [OK] to save the
setting or [CLR] to cancel the selection.
VISUAL
Press to activate the Visual Scan function {page 39,
TS-2000 page 70}.
GROUP B–4
DUAL
Press to switch the sub-receiver ON or OFF.
CTRL
Press to move the Control band to another receiver. The
frequency display of the Control band appears in a large
font. If the same band is selected for the TX band and
Control band, only “PTT” appears on the display.
LOCK
Press to lock all the keys and controls of the RC-2000.
Press and hold to unlock the keys and controls of the
RC-2000.
Q.M
Press to recall the Quick Memory channel. “Qnn”
appears, indicating which Quick Memory channel is
recalled (where “nn” = 00 ~ 09). Turn the MULTI/ CH
control to scroll through the Quick Memory channels.
METER
Press to change the meter mode between SWR, ALC,
and COMP. Press and hold to toggle the meter mode
between PWR and SWR/ ALC/ COMP.