Kenwood RC-2000 - Manual (Page 28)

24
GROUP C–2
VOX
Press to switch the CW break-in function ON or OFF.
BK DLY
Press to adjust the CW break-in delay time {TS-2000
page 42}. Select your desired break-in delay time using
the [
c ]/ [ d ] keys or by turning the MULTI/ CH control,
then press either [EXIT] or the MULTI/ CH control to
change the setting. The values range from FBK (full
break-in) to 100 which is the slowest delay time.
KEY
Press to adjust the keying speed of the electric keyer.
Select your desired keying speed using the [
c ]/ [ d ]
keys or by turning the MULTI/ CH control, then press
either [EXIT] or MULTI/ CH control to change the setting.
The adjustable keying speed is between 10 (WPM) and
60 (WPM).
RF
Press to adjust the Radio Frequency (RF) gain for the
main transceiver. Select your desired RF gain value
using the [
c ]/ [ d ] keys or by turning the MULTI/ CH
control, then press either [EXIT] or the MULTI/ CH
control to change the setting. The minimum RF gain
value is 0 and the maximum value is 255.
GROUP C–3
N.R.
Refer to N.R. in the USB/ LSB section {page 22}.
M.B.C.
Press to switch the Manual Beat Cancel function ON or
OFF. Press and hold the key to enter the manual beat
cancel frequency adjustment mode. Adjust the beat
cancel frequency using the [
c ]/ [ d ] keys or by turning
the MULTI/ CH control, then press either [EXIT] or the
MULTI/ CH control to store the setting.
FILTER
USB/ LSB/ FM/ AM mode:
Press to adjust the low cut-off or high cut-off frequency
of the DSP. Press [HI] or [LOW] to select the high or
low cut-off, then press [
c c c c c ]/ [ d d d d d ] or turn the MULTI/ CH
control to select the desired cut-off frequency. Press
[EXIT] or MULTI/ CH control to accept the new setting.
CW/ FSK mode:
Press to adjust the DSP filter width or shift frequency.
Press [SFT] to adjust the shift frequency, then press
[
c c c c c ]/ [ d d d d d ] or turn the MULTI/ CH control to select the
desired shift frequency. Press [EXIT] to accept the new
setting. Press [WID] to adjust the filter width, then press
[
c c c c c ]/ [ d d d d d ] or turn the MULTI/ CH control to select the
desired shift frequency. Press [EXIT] or MULTI/ CH
control to accept the new setting.