Kenwood RC-2000 - Manual (Page 26)

22
T-MON
Press to adjust the monitor level of your transmission
signal. Adjust the monitor level using the [
c ]/ [ d ] keys
or by turning the MULTI/ CH control, then press either
[EXIT] or the MULTI/ CH control to store the setting.
PWR
Press to adjust the output power {TS-2000 page 20}.
Adjust the output power using the [
c ]/ [ d ] keys or by
turning the MULTI/ CH control, then press either [EXIT]
or the MULTI/ CH control to store the setting.
GROUP C–2
VOX
Press to switch the Voice-Operated Transmission
function ON or OFF {TS-2000 page 39}.
V GAIN
Press to adjust the VOX gain {TS-2000 page 39}. While
pressing Mic [PTT], adjust the VOX gain using the [
c ]/
[ d ] keys or by turning the MULTI/ CH control, then
press either [EXIT] or the MULTI/ CH control to store the
setting.
V DLY
Press to adjust the VOX delay time. Select your desired
delay time using the [
c ]/ [ d ] keys or by turning the
MULTI/ CH control, then press either [EXIT] or the
MULTI/ CH control to change the setting.
RF
Refer to RF in the CW section {page 24}.
GROUP C–3
N.R.
Press to activate Noise Reduction 1, Noise Reduction 2,
or to turn the function OFF. When the noise reduction
function is ON, “N.R.1” or “N.R.2” appears above the
key. When it is ON, press and hold the key to change
the noise reduction level. Adjust the noise reduction
level using the [
c ]/ [ d ] keys or by turning the
MULTI/ CH control, then press either [EXIT] or the
MULTI/ CH control to store the setting.
A.N.
Press to switch the Auto Notch function ON or OFF.
Press and hold the key to change the Auto Notch level.
Adjust the Auto Notch tracking time constant using the
[
c ]/ [ d ] keys or by turning the MULTI/ CH control, then
press either [EXIT] or the MULTI/ CH control to store the
setting.
B.C.
Press to switch the automatic Beat Cancel function ON
or OFF. “B.C.” and “DSP” appear when it is ON.
M.B.C.
Refer to M.B.C. in the CW section {page 24}.
FILTER
Refer to FILTER in the CW section {page 24}.