Connecting wires to terminals – Kenwood KIV700 User Manual
Page 76
L
R
L
R
REMOTE CONT.
REMOTE INPUT
STEERING WHEEL
P.CONT
ILLUMI
ANT.
CONT
MUTE
iP
od
A
UDIO IN
iP
od
VIDEO IN
PRK SW
iP
od
A
UDIO OUT
iP
od
VIDEO OUT
iPod
VIDEO OUT
iPod
AUDIO OUT
76
|
KIV-BT900/ KIV-700
Connecting Wires to Terminals
FM/AM antenna input (JASO)
Antenna Cord
Wiring harness (Accessory 1)
To Kenwood disc changer/External optional
accessory
⁄
To connect these leads, refer to the
relevant instruction manuals.
Fuse (10A)
Front output
Rear output
Sub Woofer output
USB connector (1m)
⁄
Do not remove the cap when you do not use
the USB cable. The connector will cause the
unit to malfunction if it gets in touch with any
metallic part of the vehicle.
Microphone
(Accessory 7)
(KIV-BT900 only)
Microphone input
(KIV-BT900 only)
AUX input (Stereo)
Use the mini-plug (3.5 mm ø) which
is stereo type and does not have any
resistance.
iPod visual output (Yellow)
iPod audio output (Left: White, Right: Red)
For the sake of safety, be sure to connect
the parking sensor.
⁄
Connect to the vehicle’s parking
brake detection switch harness.
Parking sensor wire (Light Green)
Parking sensor wire Junction cable
(Light Green) (Accessory 3)
iPod
(commercially
available)
USB device
(commercially
available)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black)
· (To car chassis)
Ignition key switch
Car fuse box
(Main fuse)
ACC
Car fuse box
Battery
Power control/Motor antenna control wire
(Blue/White)
Motor antenna control wire (Blue)
When using the optional power amplifier, connect to its power control
terminal.
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
Mute control wire (Brown)
To car light control switch
To use the steering wheel remote control feature, you need to an exclusive
remote adapter (not supplied) matches your car is required.
Dimmer control wire (Orange / White)
Steering remote control wire
(Light Blue/Yellow)
To connect the Kenwood navigation system, consult your navigation
manual.
⁄
Connect to the terminal that is grounded when either the telephone
rings or during conversation. (KIV-700 only)
iPod cable
(Accessory 4)
If no connections are made, do not
let the wire come out from the tab.