Installing the imprinter, Removing the circuit board cover – Kodak A-61167 User Manual

Page 44

C-2

A-61167 April 2005

Installing the imprinter

Removing the circuit board
cover

1. Make sure that the scanner is powered down and there are no documents

in the feeder area.

2. Disconnect the power cord from the back of the scanner.

3. Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on

the back of the scanner.

4. Lift up the scanner door release to unlatch the scanner door.

5. Pull up to open the scanner door.

6. Remove the output tray.

7. Lift up the scanner door release again and open the scanner door past the

circuit board cover.

8. Use a Phillips-head screwdriver to remove the two screws (one front, one

back) that hold the circuit board cover in place.

Circuit board cover