Kodak A-61167 - Manual (Page 17)

A-61167 April 2005 13
Making connections
Follow the instructions for installing the IEEE-1394 (FireWire) card and the
Kodak Driver Software before you plug the scanner into the host computer.
IMPORTANT: You must install the software on the host computer before you
install the scanner.
Installing the IEEE-1394
(FireWire) card in the
host computer An IEEE-1394 six-pin connector is provided on the rear panel of the scanner
for IEEE-1394 (FireWire) connectivity.
1. Install the IEEE-1394 (FireWire) card in the host computer as described by
the instructions included with the card.
IMPORTANT: Use proper precautions to avoid static when you install the
IEEE-1394 (FireWire) card in your computer.
2. Power up the host computer after the IEEE-1394 (FireWire) card
installation is complete.
Installing the Kodak
Driver software 1. Insert the Kodak i200 Series Installation CD in the CD-ROM drive.
The installation program starts automatically.
2. Follow the onscreen instructions to install the TWAIN and ISIS drivers and
the Kodak Scan Validation Tool.
Installing the IEEE-1394
(FireWire) cable 1. Attach the beaded end of the IEEE-1394 (FireWire) cable to the IEEE-1394
port on the back of the scanner.
WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable
connector end correlates to the IEEE-1394 port configuration
before you plug the cable in. Damage to the scanner will
occur if the cable is attached in the wrong position.
IMPORTANT: Only use the IEEE-1394 cable that is supplied with the
i200 Series Scanner.