Kenwood TH-D72E - Manual (Page 42)

PACKET – 5
Command Name Short Description Parameter Default
PACTIME PACT
If set to EVERY, sends a packet at intervals of the
specified period (n). If set to AFTER, sends a packet
only once after the specified period (n). The unit of n
is 100 milliseconds.
EVERY/ AFTER n
(n = 0 ~ 250)
AFTER 10
PERSIST PE
Specifies a parameter to calculate probability for the
PERSIST/SLOTTIME method.
0 ~ 255 128
PPERSIST PP
Causes the TNC to use the PERSIST/SLOTTIME
method when ON, or the DWAIT method when OFF.
ON/ OFF ON
RESET RESET Restores the default status for all the commands. п п
RESPTIME RES
Specifies the acknowledgment packet transmission
delay. The unit of the parameter is 100 milliseconds.
0 ~ 250 5
RESTART RESTART
Causes the TNC to function as if it is switched OFF
then ON.
п п
RETRY RE Specifies the number of transmission retries. 0 ~ 15 10
ROUTE ROU
When ON and receiving a packet forwarded by a
PBBS, leaves the included route information.
ON/ OFF ON
SENDPAC SE Specifies a character which forces a packet to be sent. 0 ~ $7F $0D
SLOTTIME SL
Specifies the period of random number generation
intervals for the PERSIST/SLOTTIME method. The
unit of the parameter is 10 milliseconds.
0 ~ 250 3
SPATH SPATH
Specifies digipeater call signs to be added when the
UISSID parameter in a received packet is 9 or 13.
Call1, ... call7 ï
TRACE TRAC
When ON, causes the TNC to display all received
packets in their entirety.
ON/ OFF OFF
TRANS T
Causes the TNC to exit Command mode and enter
Transparent mode. To restore Command mode, press
and hold [Ctrl], then press [C] three times.
п п
TRIES TRI
Specifies the number of transmission retries
programmed in the retry counter.
0 ~ 15 0
TXDELAY TX
Specifies the time delay between PTT ON and start
of transmission. The unit of the parameter is 10
milliseconds.
0 ~ 120 30
UICHECK UIC
Does not forward the same UI packet as one received
within the time specified by this command. The unit of
the parameter is 1 second.
0 ~ 250 28
UIDIGI UI
When receiving a UI packet which includes the
parameter specified by this command, replaces the
parameter with the MYCALL parameter and forwards
the packet.
OFF/ ON, Call1,
... call14
OFF
UIDWAIT UIDW
When ON and digipeating, causes the TNC to use the
DWAIT and PPERSIST settings.
ON/ OFF OFF
UIFLOOD UIF
Specifies how received UI packets, which include
WIDEN-N or TRACEN-N parameters, are processed.
Enter WIDE or TRACE before ID, NOID, or FIRST; ex.
WIDE,FIRST. With ID selected, deletes the relayed
digipeaters and adds the MYCALL parameter. With
NOID, merely decrements N-N; ex. 4-3 to 4-2. With
FIRST, adds the MYCALL parameter only when
serving as the first digipeater.
Name, ID/ NOID/
FIRST
NOID
UISSID UIS
When ON, causes the TNC to process received UI
packets depending on included destination SSIDs.
ON/ OFF OFF
UITRACE UIT
The command name must be followed by up to 5
alphanumeric characters; normally WIDE or TRACE.
Causes the TNC to forward received UI packets which
include WIDEN-N or TRACEN-N parameters.
п п