Kenwood TH-D72E - Manual (Page 40)

PACKET – 3
Command Name Short Description Parameter Default
DISPLAY DISP
Causes the TNC to display the current status of all the
commands. You can also specify a class identifier A, C, H, I,
L, M, or T to display the status of only the desired command
class. Enter a space between the command name and a
class identifier; ex. DISPLAY H.
A (ASYNC): RS-232C port parameters
C (CHAR): Special TNC characters
H (HEALTH): Counter parameters
I (ID): ID parameters
L (LINK): TNC-to-TNC link status
M (MONITOR): Monitor parameters
T (TIMING): Timing parameters
п п
DWAIT DW
Specifies the interval from no carrier detection until
execution of transmission. The unit of the parameter is 10
milliseconds.
0 ~ 250 30
ECHO E
When ON, causes the TNC to echo received characters to
the computer.
ON/ OFF ON
EPATH EPATH
Specifies digipeater call signs to be added when the
UISSID parameter in a received packet is 10 or 14.
Call1, ... call7 ï
FLOVER FL
Specifies the time deday from when the TNC buffer
becomes full until the TNC buffer is cleared. The unit
of the parameter is 1 minute.
0 ~ 120 0
FLOW F
When ON, starting key entry causes the computer to
stop displaying received packets.
ON/ OFF ON
FRACK FR
Specifies the interval from one transmission until
retry of transmission. The unit of the parameter is 1
second.
0 ~ 250 3
FULLDUP FU
When ON, allows the TNC to function in full duplex.
When OFF, allows it to use data carrier detect signals
to avoid packet collision.
ON/ OFF OFF
GBAUD GB
Selects 4800 or 9600 bps as the transfer rate between
the TNC and the GPS receiver.
2400/ 4800/ 9600 4800
GPSFILT1 GPSFILT1 Filter setting of the GPS input data. 0 ~ 6 characters ï
GPSFILT2 GPSFILT2 Filter setting of the GPS input data. 0 ~ 6 characters ï
GPSFILT3 GPSFILT3 Filter setting of the GPS input data. 0 ~ 6 characters ï
GPSFILT4 GPSFILT4 Filter setting of the GPS input data. 0 ~ 6 characters ï
GPSSEND GPSS
Specifies the content of data to be output to the GPS
receiver; this data is used to program the default
settings on the receiver. The output data is not stored
in memory.
0 ~ 32 characters ï
GPSTEXT GPST
Specifies the type of a message to be determined by
LTEXT.
0 ~ 6 characters $PNTS
HBAUD HB
Selects 1200 or 9600 bps as the transfer rate between
packet stations.
1200/ 9600 1200
HEALLED HEAL
Determines whether or not normal operations of the
ROM are checked. When ON and if normal operations
are detected, “STA” and “CON” appear and blink
alternately.
ON/ OFF OFF
HID HI
When ON, causes the TNC to send an ID packet every
9.5 minutes after digipeating.
ON/ OFF ON
ID I Causes the TNC to send an ID packet. п п
KISS KISS
When ON, entering a RESTART command causes the
TNC to enter (or exit) KISS mode.
ON/ OFF OFF