Siemens CL-110-I - Manual (Page 96)

Internet - ADSL Settings
Enable ADSL Port:
Check this box to enable this function. It
simply invokes the line mode that you
choose here for the router.
Select the support of line modes:
There are several selections for your
choosing. Select the one that you need. For
Example, if you want to change one or more
physical layer parameters while the ATU-x is
in data transfer state, and the transmission
errors will not be present, please choose
ADSL2.
Capability Enabled:
Two items are provided here for you to
choose.
Bitswap:
It is a mandatory receiver initiated feature to
maintain the operating conditions of the
modem during changing environment
conditions. It reallocates the data bits and
power among the allowed carriers without
modification of the higher layer control
parameters in the ATU. After a bit swapping
reconfiguration, the total data rate and the
data rate on each latency path is unchanged.
Check this box to enable the function. If not,
uncheck this box to close the function.
Seamless Rate Adaptation:
It enables the ADSL2 system to change the
data rate of the connection while in operation
without any service interruption or bit errors.
Check this box to enable the function. If not,
uncheck this box to close the function.
IP Routing - Static Route
Routing Table shows all static route status and allows you to add new static IP route or delete IP
route. A Static IP Routing is a manually defined path, which determines the data transmitting route.
If your local network is composed of multiple subnets, you may want to specify a routing path to the
routing table.
Destination Network Address:
Display the IP address that the data packets
are to be sent.
Netmask:
Display the subnet mask that the data
transmitting is passing through.
Gateway:
Display the gateway that the data
transmitting is passing through.
WAN Interface:
Display the interface that the data
transmitting is passing through.
Delete: