Siemens CL-110-I - Manual (Page 11)

Chapter 2:System Requirement and Installation
Chapter 2: System Requirement and
Installation
System Requirement
To access the ADSL Router via Ethernet, the host computer must meet the following requirements:
™
With Ethernet network interface.
™
Must have TCP/IP installed.
™
Set client PC with obtain an IP address automatically or set fix IP address.
™
With a web browser installed: Internet Explorer 5.x or later.
The ADSL Router is configured with the default IP address of 192.168.1.1 and subnet
mask of 255.255.255.0. As the DHCP server is Enable by default, The DHCP clients should
be able to access the ADSL Router. Or you could assign an IP address to the host PC first for initial
configuration.
You also can manage the ADSL Router through a web browser-based manager: ADSL ROUTER
CONTROL PANEL. The ADSL Router manager uses the HTTP protocol via a web browser to
allow you to set up and manage the device.
To configure the device via web browser, at least one properly-configured PC must be
connected to the network (either connected directly or through an external hub/switch
to the LAN port of the device).
Choosing a place for the ADSL Router
n
Place the ADSL Router close to ADSL wall outlet and power outlet for the cable to reach it
easily.
o
Avoid placing the device in places where people may walk on the cables. Also keep it away
from direct sunlight or heat sources.
p
Place the device on a flat and stable stand.