Savin SDC410 User Manual

Page 112

Copying

Repeat Image—Copying a Part of an Original Image Repeatedly

This function copies a part of the original image repeatedly.

Note

❐

When this function is used, the leading edge margin of 10mm, 0.4" is set on the copy paper.

❐

There are three ways to specify the image of the original to be repeated as follows:

Size Input:

This function allows you to reproduce the top band of an original repeatedly down the entire
copy. You specify the width of the band (the vertical length of image) and it is repeated as many
times as will fit on the copy.

Number of Images:

This function also allows you to reproduce the top band of an original repeatedly down the entire
copy, but here you specify the number of image repetitions you want and the copier will deter-
mine the width of the top band.

Editor Area:

This function allows you to select an area of the original and reproduce it repeatedly down the
copy. The repetitions are made one below the other, and are all aligned to the right. (Only for Edit
type)

❐

For an explanation of entering numbers,

☛

see page 25.

❐

The number of repeated images that can be fit on a single sheet of copy paper is calculated automatically based upon
the copy paper size, copy paper direction and enlargement/reduction ratio.

❐

Depending on the copy paper size, copy paper direction and enlargement/reduction ratio, parts of repeated images
may be cut off.

❐

When using the Length key or the Editor Area key, parts of some repeated images may be cut off depending on the
values you enter.

Image Creation