SATO M5900RVe - Manual (Page 64)

Unit 6: Maintenance
SATO M5900RVe Operator Manual PN 9001125A Page 6-6
ADJUSTMENT PROCEDURES
To maintain optimum performance and print quality, periodically mechanical adjustments will
have to be made. These adjustments are typically required following the replacment of a
component.
Other adjustments may be required due to variations in media size or quality and due to different
print image denseness. Instructions relative to those conditions are not covered here. Refer to
the Installation and Operation units for those relative instructions.
This chapter provides instructions on the performance of those activities that are mechanical in
nature and are responsive to maintenance activities. The table below provides common print
defects and their relative cause.
PRINT DEFECTS RELATIVE PROCEDURE
Print becomes lighter or darker from one side to the other.
This condition is repetitive from label to label. Print Head Balance Adjustment
Voids in the overall print image that is repetitive from label to
label. Print Darkness Adjustment
A visible path on the label where print image is missing. The
path will change somewhat from label to label. Print Position Alignment
Platen Roller Adjustment
The scales at the lower left and right sides are not equal
distances from the labels lower edge. Print Position Alignment
The lines are not sharp. Print Darkness Adjustment
The image is too light or dark. Print Darkness Adjustment
Bar code label has a sharp line where print is missing. Print Darkness Adjustment
The printed position is too far in one direction or another. Print Position Adjustment
Offset Label Stop Position