Sharp AR-M451N - Manual (Page 47)

MISFEED REMOVAL
2-19
2
Misfeed in the duplex module
1 Unlatch the duplex module and slide it to
the left.
Unlatch the unit and
gently move the module
away from the machine.
2 If the duplex module has an exit tray,
rotate it up out of the way and open the
cover of the duplex module.
If no exit tray is attached,
just open the cover of
the duplex module and
ignore any reference to
the tray in the following
steps.
3 While holding the exit tray up, remove the
misfed paper as shown in the illustrations
below.
If paper is misfed at the
upper part of the duplex
module, gently remove it
while taking care not to
tear the paper.
If paper is misfed at the
lower part of the duplex
module, gently remove it
while taking care not to
tear the paper.
4 Close the cover of the duplex module and
lower the exit tray.
5 Gently close the duplex module.
After closing the duplex
module, confirm that the
misfeed message is
cleared and the normal
display appears.
■ ■ ■ ■ Misfeed in the bypass tray
1 Unlatch the duplex module and slide it to
the left.
Unlatch the unit and
gently move the module
away from the machine.
2 Remove the misfed from the bypass tray.
Be careful not to tear the
misfed paper during
removal.
3 Gently close the duplex module.
After closing the duplex
module, confirm that the
misfeed message is
cleared and that the
normal display appears.
Copy_EX.book 19 ページ ２００４年９月２８日 火曜日 午後９時５４分