Sharp AR-M451N - Manual (Page 35)

LOADING PAPER
2-7
2
Programming and editing paper types
To program or edit the name of a paper type or set paper attributes, follow the steps below.
1 Follow steps 1 and 2 of "Setting the paper
type and paper size"
(page 2-5)
2 Touch the [PAPER TYPE REGISTRATION]
key.
3 Select the paper type that you wish to
program or edit.
4 Touch the [TYPE NAME] key.
A character entry screen
appears.
Enter a type name
(maximum of 14
characters). (See page
7-26 to enter characters.)
5 Set the attributes of the paper tray.
Touch the checkboxes
to the left of the items to
select them.
6 Touch the [EXIT] key to exit the
programming/editing procedure.
OK
PAPER TYPE REGISTRATION
CUSTOM SETTINGS
TRAY 2 TYPE/SIZE SETTING
USER TYPE 1
USER TYPE 5 USER TYPE 6 USE
USER TYPE 2 USE
SELECT THE PAPER TYPE
FIXED PAPER SIDE
TYPE NAME
PAPER TYPE REGISTRATION
No.01
USER TYPE 1
DISABLE STAPLE
DISAB
DISAB
FIXED PAPER SIDE
TYPE NAME
PAPER TYPE REGISTRATION
No.01
USER TYPE 1
DISABLE STAPLE
DISAB
DISAB
"FIXED PAPER SIDE" : Select when paper is to be
loaded print side down in the
tray. Make sure a checkmark
does not appear when paper is
to be loaded print side up.
• If the two-sided function is
prohibited in "DISABLING OF
DUPLEX" in the key operator
programs (page 11 of the Key
operator’s guide), do not use
this setting.
"DISABLE DUPLEX" : Prohibits two-sided printing.
Enable when the back side of
the paper cannot be printed on.
"DISABLE STAPLE" : Prohibits stapling. Enable
when using special papers
such as transparency film and
label sheets.
"DISABLE PUNCH" : Prohibits punching. Enable
when using special papers
such as transparency film and
label sheets.
NOTE
"FIXED PAPER SIDE" and "DISABLE DUPLEX"
cannot be simultaneously enabled.
DISABLE DUPLEX
DISABLE PUNCH
EXIT CANCEL
Copy_EX.book 7 ページ ２００４年９月２８日 火曜日 午後９時５４分