Sharp DV-AT4000 - Manual (Page 21)

21
DV-AT4000
Preparation f
o
r U
s
e
- Gener
a
l c
o
ntr
o
l -
General control
" To turn the power on
" To change the display brightness (3 levels)
You can switch the display brightness by pressing the DIMMER button.
Each time the button is pressed, the display brightness changes in the following
order.
1
Set the POWER switch on the main unit to ON.
The stand-by indicator lights up.
2
When the stand-by indicator is lit, you can turn the power on or put
the unit in stand-by mode, using the ON/STAND-BY button on the re-
mote control.
After use:
When not using this unit, set the POWER switch on the main unit to OFF.
The stand-by indicator will go out.
Brightened
Dimmed
Dimmed further