Sharp MD-E9000H - Manual (Page 29)

29 Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
RDS Radio
- Using the Radio Data System (RDS) -
MD-E9000H
■ To automatically play the traffic information
(EON-TI)
When the traffic information is broadcast, the radio switches to it automatically.
1
Tune in to an RDS station (when a station name is displayed).
2
Press the EON button when “EON” appears.
● “PTY TI” will flash for about 4 seconds.
● If the EON button is pressed when “EON” is not displayed, “NO EON” will
appear for 4 seconds to indicate that the unit cannot enter the EON stand-
by mode.
3
Whilst they are displayed, select the TI (Traffic Information) by
pressing the
5/3 5/3 5/3 5/3 5/3
or
2/4 2/4 2/4 2/4 2/4
button.
4
Within 4 seconds, press the PTY. TI button.
● “TI” and “WAITING” will appear for 2 seconds each.
● “TI” will appear, and the unit will enter the EON-TI stand-by mode.
Using the Radio Data System (RDS) (continued)
5
When a TA specified starts on an ON (other network) station, the
unit will automatically switch to that station, and “TI” will flash.
6
When the traffic information is over, the unit will automatically
return to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. (“TI” → “WAITING”)
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again. (“TI” will go out.)
11
12
10
9
8
6
7
5
4
3
2
1
*MD9000H-E24-30 2001.4.20, 2:11 AM 29