Sherwood R-772 - Manual (Page 6)

• There are three types of video jacks (COMPONENT, S-
VIDEO, (composite) VIDEO) for analog video connections
and the HDMI connectors for digital video and audio
connections. Connect them to the corresponding video
jacks according to their capability.
• For your reference, the excellence in picture quality is as
follows : "HDMI” > "COMPONENT" > "S-VIDEO" >
"(composite) VIDEO" .
• When making COMPONENT VIDEO connections, connect
"Y" to "Y", "P B /C B " to "C B "(or "B-Y", "P B ") and "P R /C R " to
"C R "(or "R-Y", "P R ").
• When recording video program sources through VIDEO 1 OUT jacks or viewing ROOM 2 source through
ROOM 2 OUT jacks, you must use the same type of video jacks that you did connect to video playback
components such as DVD player, cable TV tuner, etc.
• This unit is equipped with a function that up-converts composite video or S-Video signals to component
video signals or down-converts S-Video signals to composite video signals and outputs them from the
MONITOR OUTs.
Because of this, you need not connect all the types of the MONITOR OUT jacks to the MONITOR TV.
• After connecting the video components, you should set the video mode correctly, referring to the following
table on page 7. (For details, refer to "When selecting the VIDEO MODE" on page 54.)
ENGLISH
6
2.
CONNECTING VIDEO COMPONENTS
• The jacks of VIDEO 1 may also be connected to a DVD recorder or other digital video recording
component.
For details, refer to the operating instructions of the component to be connected.
• The jacks of VIDEO 2/VIDEO 3 can also be connected to an additional video component such as a cable
TV tuner or satellite system.
• Connect the jacks of VIDEO 3 to the video component in the same way.
R-772(A) 2007.8.16 5:21 PM 페이지 6