Sherwood R-772 - Manual (Page 20)

20
USING FUNCTIONS OF REMOTE CONTROL
ENGLISH
Entering a setup code
• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup code for each
component should be entered.
• For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD
player, "DVD" for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV respectively as its factory
setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.
� Note :
• If the transmission signal which this remote control emits is changed into "RF"(Radio Frequency), this remote contol cannot
control other audio and video components. (For details, refer to "Changing the transmission signal" on page 28.)
• Then "LEARN" is displayed on the LCD screen for
several seconds.
� Notes :
• The AUDIO button is unavailable for the audio
components other than this receiver.
• During setting operation, to exit from the setting mode,
press any of the DEVICE buttons.
• Setup code entry is the easiest way to program this
remote control for operating audio and video
components.
1.
Turn on the component you want to operate.
2.
Find the setup codes according to the type and
the brand name of your component, referring to
"Setup Code Table" on page 73.
3.
Press and hold down both the ENTER button
and the desired one of the DEVICE buttons for
more than 2 seconds.
4.
While "LEARN" is displayed, press the CURSOR
UP( ▲ )/DOWN( ▼ ) buttons to select the setup
code mode ("CODE"), then press the ENTER
button.
5.
While "PRESET", etc. are displayed, enter a 3
digit code and press the ENTER button, aiming
the remote sensor on the component.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ ) buttons are
pressed, the mode changes as follows :
� LEARN � RF-IR � DELETE � MACRO �
� CODE � PUNCH �
• Then "PRESET" and 3 digit number are displayed.
• If "PRESET", etc. go off, start again from the above step 3.
Example: When entering "001".
• Then "OK" is displayed on the LCD screen.
• To be sure that the setup code is correct, press the
POWER ON (or STANDBY) button.
• If the setup code is correct, your component will be
turned off.
• When your component is not turned off, repeat the
above steps 2 to 5, trying entering each code for your
component until you find one that works.
• If "NG" is displayed, retry entering the correct setup
code while "PRESET" and 3 digit number are
displayed.
R-772(A) 2007.8.16 5:21 PM 페이지 20