Sherwood R-772 - Manual (Page 23)

23
ENGLISH
Erasing the programmed command from
one button
• "OK" is displayed and then "SEL" is flickering.
• Then "BTTN" is displayed on the LCD screen for
several seconds.
Example: When the button for the command to be
erased is PLAY button.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, "BTTN" or "LEARN"(all
command deleting mode) is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 1.
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the
delecting mode ("DELETE").
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the
deleting mode ("DELETE").
2.
While "BTTN" is displayed, press the CURSOR
UP( ▲ )/DOWN( ▼ ) buttons to select the all
command deleting mode ("LEARN"), then press
the ENTER button.
3.
While "SURE?" is displayed, press the ENTER
button.
4.
To erase all the commands programmed under
other device mode, repeat the above steps 1 to
3.
2.
While "BTTN" is displayed, press the CURSOR
UP( ▲ )/DOWN( ▼ ) buttons to select the one
command deleting mode (BTTN), then press the
ENTER button.
3.
While "SEL" is flickering, press the button for the
command you want to erase.
4.
While "SEL" is flickering, repeat the above step
3 to erase other commands.
Erasing all the commands programmed
under a device mode
• Then all the commands programmed are erased.
• Then "BTTN" is displayed on the LCD screen for
several seconds.
• Then "SURE?" is displayed .
• If "SURE?" goes off, start again from the above
step 1 .
R-772(A) 2007.8.16 5:21 PM 페이지 23