Sherwood R-772 - Manual (Page 27)

ENGLISH
27
3.
While the device is displayed, press the
CURSOR UP(
▲ )/DOWN( ▼ ) buttons to select
the one punch-through deleting mode
("DELETE"), then press the ENTER button.
2.
While "VOL" is displayed, press the CURSOR
UP(
▲ )/DOWN( ▼ ) buttons to select the all
punch-through deleting mode ("DELETE").
3.
While "DELETE" is displayed, to erase all the
punch-through functions programmed under the
master device mode, press ENTER button.
4.
To erase all the punch-through functions
programmed under other master device mode,
repeat the above steps 1 to 3.
4.
While the punch-through mode is displayed,
repeat the above steps 2 and 3 to erase other
punch-through function under the same master
device mode.
5.
To erase punch-through functions under other
master device mode, repeat the above steps 1
to 4.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, depending on the
selected punch-through mode, the punch-
through devices and the deleting mode
("DELETE") are selected.
• Then "OK" is displayed and the current punch-
through mode is displayed .
• Then "OK" is displayed and "DELETE" is
displayed.
• To exit from the deleting mode, press any of the
DEVICE buttons.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, the mode changes as
follows:
→ VOL � DELETE � PLAY � CH ←
• Then "DELETE" is displayed .
Continued
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select a master
device and the punch-through mode ("PUNCH").
Erasing all the punch-through functions
programmed under a master device mode
• Then "VOL" is displayed on the LCD screen for
several seconds.
R-772(A) 2007.8.16 5:21 PM 페이지 27