Sherwood R-772 - Manual (Page 26)

ENGLISH
26
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, depending on the selected
punch-through mode, punch-through devices
and the one punch-through deleting mode
("DELETE") are selected as follows :
• In case of the volume punch-through,
→ AUDIO � DELETE � TV ←
• In case of the transport punch-through,
→ CD � DELETE � DVD � VCR � AUX ←
• In case of the channel punch-through,
→ TV � DELETE � SAT � CABLE � VCR ←
• Then "OK" is displayed and the current punch-
through mode is displayed.
3.
While the device is displayed, press the
CURSOR UP(
▲ )/DOWN( ▼ ) buttons to select
the desired punch-through device, then press
the ENTER button.
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select a master
device and the punch-through mode ("PUNCH").
2.
While "VOL" is displayed, press the CURSOR
UP(
▲ )/DOWN( ▼ ) buttons to select the punch-
through mode to be erased, then press the
ENTER button.
4.
While the punch-through mode is displayed,
repeat the above steps 2 and 3 to program other
punch-through function under the same master
device mode.
5.
To program punch-through functions under
other master device mode, repeat the above
steps 1 to 4.
Operating a punch-through function
• While this remote control is set to control a
master device, aim the remote control at the
REMOTE SENSOR of the punch-through device
and press the desired button of the programmed
punch-through controls.
Example: When pressing "PLAY ( ▶ )" button.
• Then the punch-through device is displayed on
the LCD screen.
Erasing the programmed puch-through
function
• Then "VOL" is displayed on the LCD screen for
several seconds.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, the mode changes as
follows:
→ VOL � DELETE � PLAY � CH ←
• Then the device is displayed .
Continued
R-772(A) 2007.8.16 5:21 PM 페이지 26