Sharp XL-S10 - Manual (Page 24)

03/12/18 XL-S10(U)3.fm
24
XL-S10
TINSEA018SJZZ
Adv
a
nced F
eatures
Timer and sleep operation (continued)
To reset or change the timer setting:
Perform "Timer playback" from the beginning.
" Sleep operation
To cancel the sleep operation:
Press the ON/STAND-BY button while "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, press the SLEEP button until "OFF" appears on the
display.
To confirm the remaining sleep time:
Press the SLEEP button once while the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
" To use timer and sleep operation together
Example: To fall asleep and wake up to the same radio station
You can play back the same source only (the function cannot be
switched).
7 When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the volume
you were listening at before your system enters the timer stand-
by mode.
8 The unit will enter the stand-by mode one hour after the
timer playback starts. However, when CD playing time is
one hour or less, it will enter the stand-by mode after com-
pleting playback.
1 Play back the desired sound source.
2 Press the SLEEP button.
To change the sleep time:
Press the SLEEP button repeatedly to select the desired sleep
time. The time will decrease as follows.
The amount of sleep time can also be changed while in the
sleep mode.
3 Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep op-
eration finishes.
3:00 2:00
OFF 15 30
1:30
10 5
1:00
1 Set the sleep time (steps 1 - 2, page 24).
2 While the sleep timer is set, set the timer playback start
time (steps 4 - 6, page 23).
1.Sleep timer setting
2.Timer playback setting
Timer playback
start time
5 minutes - 3 hours
Sleep operation will
automatically stop.