Sharp XL-S10 - Manual (Page 15)

03/12/18 XL-S10(U)2.fm
15
XL-S10
TINSEA018SJZZ
CD Playb
ack
To stop playback:
Press the button.
To remove the CD:
While in the stop mode, press the CD EJECT button.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Caution:
! If a disc is damaged, dirty, or loaded upside down, "no dISC" will
appear on the display.
! Keep foreign objects out of the CD compartment.
! Subjecting the unit to shock or vibration may cause mistracking.
! When the unit is not being used, be sure to close the CD com-
partment. If it is left open, the lens may be covered with dust and
the unit may not operate properly.
! If TV or radio interference occurs during CD operation, move the
unit away from the TV or radio.
" To locate the beginning of a track
" To locate the desired portion
Notes:
! Normal playback will resume when the ( ) or ( ) but-
ton is released.
! When the end of the last track is reached during fast forward,
"End" will appear on the display and CD operation will be paused.
When the beginning of the first track is reached during fast
reverse, the disc will start playback automatically.
To interrupt playback:
Main unit operation:
Press the
button.
To resume playback from the same point, press
the
button again.
Remote control operation:
Press the button.
To resume playback from the same point, press the button.
To move to the beginning of the next track:
Press the button for less than 0.5 seconds during playback.
! You can skip to any track by pressing the
button repeatedly until the desired track
number appears.
To restart the track being played:
Press the button for less than 0.5 seconds during playback.
! You can skip to any track by pressing the
button repeatedly until the desired track
number appears.
For audible fast forward:
Press and hold down the button on the main unit or the but-
ton on the remote control during playback.
For audible fast reverse:
Press and hold down the button on the main unit or the but-
ton on the remote control during playback.
4