Sharp XL-S10 - Manual (Page 21)

03/12/18 XL-S10(U)3.fm
21
XL-S10
TINSEA018SJZZ
T
a
pe Rec
o
rding
Recording to a cassette tape
Before recording:
! When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
! SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
! The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
! For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Recording from a CD
To perform programmed recording:
To interrupt recording:
Press the button.
To resume recording, press the button.
To stop recording:
Press the button.
The tape will stop.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the FUNCTION button until "Cd dISC" appears on the
display.
When operating with the remote control, press the CD button.
3 Load the desired disc.
4 Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5 Press the button.
6 Press the button, which also en-
gages the button.
7 Press the button again to cancel the pause mode.
8 Press the ( ) button for CD.
1 Program tracks (see page 17).
2 Press the button.
3 Press the button, which also engages the button.
4 Press the button again to cancel the pause mode.
5 Press the ( ) button for CD.
6