Sharp XL-S10 - Manual (Page 19)

03/12/18 XL-S10(U)2.fm
19
XL-S10
TINSEA018SJZZ
Radio
Listening to the memorized station
" Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few
hours should there be a power failure or the AC power cord get dis-
connected.
" To recall a memorized station
" To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
" To clear a memorized station
1 Perform steps 1 - 3 in "Listening to the radio" on page 18.
2 Press the MEMORY/SET
(MEMORY) button to enter the
preset tuning saving mode.
3 Within 5 seconds, press the
PRESET ( or ) button to se-
lect the preset channel num-
ber.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 5 seconds, press the
MEMORY/SET (MEMORY)
button to store that station in
memory.
If the "MEMORY" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorized will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
Preset channel Frequency and frequency band
1 Press the PRESET ( or ) button for more than 0.5 sec-
onds.
The preset number will flash and the programmed stations will
be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Recall the memorized station.
2 While it is displayed, press the MEMO-
RY/SET (MEMORY) button.
3 Within 5 seconds, press the CLEAR but-
ton on the remote control.
5