Siemens M101 - Manual (Page 19)

LEDs and buttons
19
gigam101.fm5 21.4.99 Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1
LEDs and buttons
There are two LEDs and a black button on the front of the Gigas-
et M101 Data unit.
Both button functions
Setting a Basis to logon mode
Press the button on a powered base-type device for 10 seconds.
The two LEDs blink in sequence, thus indicating that the device
is in logon mode. Logon mode is automatically deactivated after
successful logon or after 10 minutes: the blinking stops.
Resetting the device to the factory default
Press and hold down the button on the device that has been dis-
connected from the mains. Connect the device to the power
supply while holding the button down. LED 2 lights up after 10
seconds. This LED goes out in another 10 seconds indicating
that the reset operation has been successful. The button can
then be released.
LED 1: Gigaset M101 Data status
LED 1 indicates stand-by mode:
LED 2: data transfer
LED 2 indicates the status of the transmission route on the
V.24/RS232 interface:
LED 1 blinks The station is searching for the part-
ner or has not been registered.
LED 1 is constantly il-
luminated
The partner was found, the transmis-
sion route is on stand-by.
LED 2 off No data transfer
LED 2 flickers Data transfer active