Siemens M101 - Manual (Page 13)

Configuration program options
13
gigam101.fm5 21.4.99 Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1
"Connection" tab
Upper section: connecting to the PC
You can set the COM port of the PC at which the lokale Station
is connected in the upper section of the tab.
It is easiest to leave the option No automatic detection deacti-
vated (as shown). The program then checks the existing COM
ports and determines where the station is connected. Manual
interface selection is only recommended if there is more than
one Gigaset M101 Data unit connected to the PC.
As soon as the program finds a station or identifies the manually
selected interface, it sends it the configuration command via
the control lines. The station is thus switched to configuration
status. This is indicated by the Status display in the dialog box.
Gigaset M101 Data can only be configured under these condi-
tions. At the end of the program, your Gigaset M101 Data will
automatically switch the station back to operating mode.
Lower section: radio connection
This sections indicates whether a radio connection exists and if
so, to which partner station. It also indicates the quality of the
connection.
A station must be registered before it can be selected here.