Siemens M101 - Manual (Page 14)

Configuration program options
14
gigam101.fm5 21.4.99 Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1
"Operating mode" tab
Important:
If one station is set to "AT commands, local" or "AVM/Eumex
commands, local", the other station must switch to the corre-
sponding "AT commands, remote" or "AVM/Eumex commands,
remote" operating mode. And if one station is switched to "Di-
rect connection", the other station must also be switched to this
mode. The appropriate switches are performed automatically if
you select an operating mode for an Gigaset M101 Data unit.
Setting the operating mode
Open the Operating mode tab and select one of the five modes:
The three connection types are used for different purposes:
Direct connection The transmission parameters for the PC’s
COM port are manually set at the compu-
ter without automatic baud rate or data for-
mat recognition. This is always useful if the
device at the Partnerstation does not sup-
port baud rate or data format recognition
as performed by conventional modems,
e.g. in the case of a second PC.
AT commands
lokalen Station
(PC)
➔
page 33
Automatic recognition of the transmission
parameters based on the data from the PC
at the lokalen Station.
AT commands
Partnerstation
(device)
➔
page 33
Automatic emulation of the transmission
parameters based on the values received
from the PC at the Partnerstation.
AVM / Eumex
lokalen Station
(PC)
➔
page 34
Automatic recognition of the AVM / Eumex
transmission parameters based on the
data from the PC at the lokalen Station.