Smeg C6GGXU - Manual (Page 9)

Instructions for the User
11
4. USING THE RANGETOP
WARNING
FIRE HAZARD
- Do not allow the burner flame to extend beyond the
edge of the pan.
- Turn off all controls when the range is not in use.
NOTE: Check that the burner heads, burner caps and grates are correctly positioned.
Before lighting the rangetop burners, check that
each burner head is correctly positioned with its
respective burner cap, making sure that the slots
A in the burner heads are aligned with the spark
electrode and thermocouple. For the dual
burner, place the burner caps G and F on the
burner head D, ensuring that they fit snugly. The
burner head must then be placed on and fitted
into the drip tray B (taking care to use the pin C as a guide). The supplied drip tray B is for use with woks.
The special pan stand H is for use with woks.
4.1 Ignition safety device
Each burner knob has a marking corresponding to the burner it controls (the example at the left shows
the front left burner).
The appliance is equipped with spark electrode ignition.
- Just press in and turn the knob counterclockwise to the minimum flame symbol until the burner
turns on.
- Keep the knob pressed in for about 2 seconds to keep the flame lit and to activate the safety device.
- After turning the burner on, it is recommended that the knob be left in the minimum flame position for
approximately 20 seconds before adjusting it to the desired flame intensity.
The flame may go out when the knob is released. In this case, repeat the operation, but keep the knob
pressed in for a longer period of time.
NOTE: If the flame goes out accidentally, the safety device will engage after about 20 seconds, shutting
off the gas flow, even when the burner gas valve is open.
REMEMBER: When the rangetop is in use, the entire range area may become hot.