Sony CD300 - Manual (Page 96)

masterpage:Left
filename[D:\WORKS\CD\3067951111\3067951111MVCCD200UC\02GB-
MVCCD200UC\09add.fm]
96
model name1[MVC-CD200/CD300]
[3-067-951-11(1)]
The image cannot be
played back on the CD-
ROM drive of your
computer. • The disc has not been finalized.
t Finalize the disc (page 32).
• An error occurs during recording by vibration.
t Possibly, you may be able to play back images if
you connect the camera to your computer with
the USB cable.
• The CD-ROM drive does not correspond to the
packet-write system or does not conform to the
MultiRead type.
t Consult the computer or the CD-ROM drive
manufacturer.
• Causes not described above are occurred.
t Consult the computer or software manufacturer.
Your camera cannot delete
an image. • The disc is not initialized.
t Initialize the disc (page 18).
• The disc space is not sufficient.
t This is not a malfunction.
• The image is protected.
t Cancel the protection (page 78).
The power turns off
suddenly. • If you do not operate the camera for about three
minutes while the power is on, the camera turns off
automatically to prevent wearing down the battery
pack.
t Turn on the camera.
• The battery pack is discharged.
t Replace it with a fully charged battery pack.
The image does not
appear on the TV screen. • The [VIDEO OUT] setting of your camera is
incorrect.
t Change the setting (page 85).
The SLIDE SHOW
function stops
automatically. • The SLIDE SHOW function stops after about
20 minutes.
t To continue the slide show, select [START]
again (page 74).
The macro function does
not work. • [SCENE SELECTION] is set to [LANDSCAPE] in
the setup settings.
t Cancel the SCENE SELECTION function
(page 58).
• [CONVERSION LENS] is set to [ON] in the setup
settings (MVC-CD300 only).
t Set it to [OFF] (page 85).
Symptom Cause and/or Solution
01cov.book Page 96 Thursday, March 8, 2001 4:59 PM