Rotation sending setting, I-fax receive settings, Auto receive reduce setting – Sharp MX-M850 User Manual
Page 630: Duplex reception setting, Set address for data forwarding, A3 rx reduce, Pop3 communication timeout setting, Printing page number at receiver
60
Rotation Sending Setting
When transmitting an image that is one of the following
sizes, this function rotates the image counterclockwise
90 degrees. (The setting can be configured separately
for each size.)
8-1/2 x 11", 5-1/2" x 8-1/2"R, A4, B5R, A5R, 16K
Printing Page Number at Receiver
When the transmitted image is printed by the receiving
machine, the page number can be added to the top of
each printed page.
I-Fax Receive Settings are described below.
Auto Receive Reduce Setting
When a fax is received that includes printed information
such as the sender's name and address, the received image
is slightly larger than the standard size. This setting is used
to automatically reduce the image to fit the standard size.
Duplex Reception Setting
This is used to select whether or not received faxes are
printed on both sides of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
Set Address for Data Forwarding
When the machine is unable to print a received fax, the
fax can be forwarded to another machine. This setting is
used to configure the address of the other machine.
Enter the forwarding address (maximum of 64 characters).
A3 RX Reduce
When an A3 size fax is received, this function reduces
the fax to W letter size.
POP3 Communication Timeout Setting
The duration of time the machine waits until stopping
reception when a response is not received from the mail
server (POP3 server) can be set from 30 to 300 seconds
in increments of 30 seconds.
8-1/2"x11"R and A4R size images are not rotated.
I-Fax Receive Settings
• If Auto Receive Reduce is disabled, the edges of
the image outside the standard size will be cut off.
However, the image will be clearer because it will
be printed at the same size as the original.
• Standard sizes are sizes such as 8-1/2" x 11" and
8-1/2" x 5-1/2" (A4 and B5).
Multiple forwarding addresses cannot be stored.
When this setting is enabled, W letter size faxes are
also reduced.