Sending a fax at a specified time (timer), Timer – Sharp MX-M850 User Manual

Page 418

SENDING A FAX AT A SPECIFIED TIME
(Timer)

This function lets you specify a time at which a transmission or broadcast transmission will automatically take place.
Transmission begins automatically at the specified time.
For fax, this function is convenient for performing a transmission reservation or broadcast transmission when you are
not present or at night when telephone charges are less expensive. A timer setting can also be specified for polling
reception to receive a fax when you are not present.

• When a timer transmission is stored, keep the main power switch in the "on" position. If the main power switch is in the "off"

position at the specified time, transmission will not take place.

• When performing a timer transmission, you must scan the original into memory when you set up the transmission. It is not

possible to leave the document in the auto document feeder or on the document glass and have it scanned at the specified
time of transmission.

• Settings selected for a timer transmission (exposure, resolution, special modes, etc.) are automatically cleared after the

transmission is finished. (However, when the document filing function is used, the scanned original and settings are stored
on the built-in hard drive. For more information on the document filing function, see the Document Filing Guide.)

• This function cannot be used in USB memory mode.

Place the original.

Place the original face up in the document feeder tray, or face down on the document glass.

Specify the destination.

☞

2. ENTERING DESTINATIONS

(page 25)

Select the special modes.

If the base screen is not displayed, touch the [Condition Settings] key.

(1) Make sure that the desired mode is selected.

If the desired mode is not selected, touch the tab of that mode.

(2) Touch the [Special Modes] key.