7) network setting function and setting method, Static ip user – Samsung SMO-211QN User Manual

Page 41

Eng-41

3-7) NETWORK SETTING function and setting method

This section of the manual is intended for users who will install this security system in a network

environment.If you have difficulty setting the network,we recommend contacting your network administrator.

•

Function: Allows users to select the STATIC (fixed) IP, DHCP, PPPoE of Setting.

•

Setting method: Move to #7, NETWORK SETUP MENU by using

▲/▼ KEY in the SETUP

MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.

(The figure shows the initial setting status)

MOVE TO EACH item by using

▲/▼ KEY, and using œ

œ / √

√ KEY to change the set value.

Static IP User

- Constituted by Static IP on the TCP/IP network

1) Move to ‘STATIC...’ by using

▲/▼ KEY at NETWORK ACCESS, then press ENTER SWITCH

to set STATIC...

(STATIC : Select in case the network configuration of monitor is fixed IP (Public or Private IP)

2) Move to IP ADDR / GATEWAY / SUBNETMASK by using

▲/▼ KEY.

3) Press ENTER SWITCH and type in IP ADDR / GATEWAY / SUBNETMASK respectively.

4) DNS 1 and DNS 2 will be automatically set to DNS as shown above.

Use œ

œ / √

√ KEY to change it.

06/01/03

13:14:00

NETWORK SETTING

1. NETWORK ACCESS

STATIC.../DHCP.../PPPoE...

2. HTTP PORT

00080

NETWORK STATUS

IP ADDR

192.168.1.200

GATEWAY

192.168.1.65

SUBNETMASK

255.255.255.0

DNS 1

168.126.63.001

DNS 2

168.126.63.002

MAC ADDR

00:30:6f:ff:00:00