Samsung SMO-211QN - Manual (Page 40)

Eng-40
3-6) ALARM MENU Function setting
• Function: Allows users to set the ALARM MODE for each camera.
• Setting method: Move to #6. ALARM MENU by using ▲/▼ KEY in the SETUP MENU, and
press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows
the initial setting status.)
(1) CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function canceling)
(2) HOLD TIME item sets time to freeze alarm operation when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)
(3) ALARM ON/OFF TIME item sets beginning time (ON) and end time (OFF) that monitor
recognizes as alarm event.
* Note :Even if CAMERA ALARM is set to ON, alarm operation is not carried at time band except
pre-set ALARM ON/OFF TIME.
(4) BUZZER sets whether or not buzzer(high-pitched tone)sounds when an ALARM or
VIDEO LOSS occurs.
(ON: BUZZER operation, OFF: Cancel)
[S] - Static IP (41page) , [D] - DHCP (43page) , [P] - PPPoE (46page)
06/01/03 13:14:00
CAM1 ON
CAM2 ON
CAM3 ON
CAM4 ON
CAM5 ON
CAM6 ON
CAM7 ON
CAM8 ON
HOLD TIME 05SEC
ALARM ON TIME 00:00
ALARM OFF TIME 00:00
BUZZER ON
ALARM SETTING