SMC Networks SMC TigerStack II SMC6624M - Manual (Page 48)

3-14
Using the Command Line Interface (CLI)
Using the CLI
U
si
n
g t
h
e Co
m
m
a
n
d
Li
ne
In
te
rf
ac
e (
C
LI
)
VLAN Context. Includes VLAN-specific commands that apply only to the
selected VLAN, plus Manager and Operator commands. The prompt for this
mode includes the VLAN ID of the selected VLAN. For example, if you had
already configured a VLAN with an ID of 100 in the switch:
Figure 3-11. Context-Specific Commands Affecting VLAN Context
SMC TigerSwitch 10/
100(config)# vlan 100 Command executed at configura-
tion level to enter VLAN 100
context.
SMC TigerSwitch 10/100(vlan-
100)# Resulting prompt showing VLAN
100 context.
SMC TigerSwitch 10/100(vlan-
100)# ? Lists commands you can use in the
VLAN context, plus Manager, Oper-
ator, and context commands you
can execute at this level.
In the VLAN
context, the
first block of
commands in
the "?" listing
show the
commands that
will affect only
vlan-100.
The remaining
commands in
the listing are
Manager,
Operator, and
context
commands.